Telephone: +44 (0) 20 8281 6370

Telephone: +44 (0) 20 8281 6370

Clarea HC 62
ProSolv5408e

HC 62

Non-chlorinated surface cleaning agents for safe removal of dirt, oil, grease and other contaminants.
Flash Point over 60°C.

Clarea Solvent Cleaners | Clarea HC62 Solvent Cleaner

Non-chlorinated industrial solvent cleaner for safe removal of dirt, oil, grease and other contaminants

DESCRIPTION
Clarea® HC62 is an aliphatic hydrocarbon based low odour degreasing solvent with a flash point over 60C. It will remove oils, greases, hydraulic fluids cutting fluids and a wide variety of hydrocarbon based protective coatings. It is suitable in ultrasonic systems and can be used as dip, brush or in hand-wipe process.

MATERIALS COMPATIBILITY
Clarea® HC62 is compatible with all metals and many plastics and other composite materials.

PROCESSING
• To reduce solvent losses keep containers closed.
• Dip tanks should have a suitable close fitting lid which should be closed when not in operation.
• Stubborn soils can be worked with a brush.
• If using with ultra-sonics set frequency to 25kHz and ensure temperature does not exceed 40°C (optimum).
• Excess solvent can be removed with cloth.
• Allow components to air dry in ventilated area.
• Blowing air over the components will aid drying.

Suitable equipment which can be used with Clarea® HC62 is shown here.
Technical data sheets can be downloaded in PDF format here.

HEALTH & SAFETY
Clarea® HC62 is a non-carcinogenic solvent mixture that is safe to use in many applications and is a not classified as flammable. Enviro Tech recommends that safe work practices are implemented whenever handling chemicals of any kind to minimise exposure levels and prevent toxic effects.

Please refer to the Clarea® HC62 Material Safety Data Sheet available on request at here for more specific information on workplace exposure levels, toxicity and personal safety recommendations.

REGULATORY INFORMATION
Clarea® HC62 is classified as non-hazardous for transport. Clarea® HC62 has been shown to neither deplete the ozone layer nor contribute significantly to global warming.

Solvent Properties

Typical Physical Properties

Boiling Point (°C ) minimum188°C
Boiling Point (°C ) maximum209°C
Specific Gravity @ 15°C (H20=1)0.78
Colour Saybolt ASTM D156+30
Aromatics mg/kg<100
Benzene mg/kg<3
Flash Point TCC (°C) minimum62°C
Auto ignition temperature255°C
Flammability Limits (vol. %)0.6 – 6.0 %
Vapour Pressure @ 20°C (mm Hg)<1
Vapour DensityHeavier than air
Evaporation Rate (Butyl Acetate = 1)0.04
Specific Heat @ 25°C (KJ/kg/°C)2.0
AppearanceClear & free of suspended matter

Cleaning, Corrosivity, Residue

Kauri Butanol Number31
Copper corrosion (3hr @ 100°C) ASTM D1301
Doctor test ASTM D235Negative
Non-Volatile Residue (ppm)10
The above represents typical properties of Clarea® HC62 degreasing and cleaning solvent, but do not represent any other product specification.

Other Clarea® HC62 products have similar characteristics, but are not necessarily identical to the properties listed above. For specific values and specifications, consult the product’s Certificate of Analysis.

Packaging

Clarea® HC62 is available in the following container sizes:
205 lt drum
25 lt can
5 lt can

Share this page: